Powder Recovery System
The function of a powder recovery system is to collect the over sprayed material and render it suitable for recycling and at the same time to remove the powder particles from the exhaust air stream before discharging into the atmosphere.
We provide three types of powder recovery system, offering the best solution to eliminate profit loss due to expensive wastage and costly downtime for powder change.
In continuous coating lines, it is mostly common to install mono cyclone and after filter together. In this way, the efficiency of the equipment is approximately 99.9%. Elcoat recovery systems are produced at high quality and designed for each single project.
Mono cyclone + after filters recovery system
It is ideal for single as well as multi color operations. Cyclone separator is used to separate the over sprayed powder in the air-flow. The working principle is based on centrifugal effect.
Multi cyclone + after filters recovery system
It is an improved technology based on mono-cyclone. The small height of cyclones allow for easy mobility and faster cleaning operation.
Twin filter cartridge recovery system
Our filter cartridge system is an improved technology, ideal for multi color powder . Normally we equip the filter cartridge at each side of the auto booth, the knock-down design enables really quick color change and easy clean.
Powder sieving system
During powder spraying process, some powder is not ionized and does not settle down on the intended parts. To recover the powder, it is collected at recovery section with the aid of cyclone or filters. To reuse the powder and mix the new powder with the used one, it is necessary to apply the sieving machine in the process. To reduce cost and optimize the system, the sieving machine can play an effective role in the coating system. The features are as follow:
- Possible control on vibration rate
- No waste in time or labor force
- Powder loss prevention
- Permanent installation on automatic systems
Powder Center
The advantages of powder center:
– Designed for quick color changes
– Using the powder directly from the original container
– An independent exhausting air system prevents powder loss
– An even powder output due to level-controlled injectors
– Automatic internal cleaning of the injectors, hoses and guns
– Optimum powder quality due to built-in sieving machine
